Measure the pole at the point where it intersects the string, and then subtract the distance from the deck to the liner track, or bead. For the deep end depth (C), run a tight string (or flexible measuring tape) across the deep end, on the edge of the hopper and use a pool pole, or other long pole, placed into the corner of the hopper. To measure depth of shallow end (D), just use a rigid measuring tape, being careful to measure from the bead or track, to the flat floor. However! Most pools will vary from the original specs, and can slightly shift over a period of many years, so it’s always recommended to remeasure the pool, completely. You may have measures available from a previous liner order, or you can probably dig up the original spec sheet which shows the length, width, depth and radius of the corners. However! Many pools are built just slightly askew, and end-up a few inches off from spec.To be sure that you order a correctly fitting liner, measure your pool correctly, and double check your measurements. And, most pools have square measures – with both ends and both sides being the exact same length. The corners of the pool, at the top of the wall, have a specific radius measurement. Most inground vinyl pools have a geometric floor shape, with precise angles. Or if not, here’s some help: Measuring your PoolĪccurate measurements are key to getting a liner that fits like a glove. I will assume you have already measured your in-ground pool with our liner measuring forms, following the steps in a previous blog post written by Jackie on how to measure for an inground vinyl liner. Replace your own inground pool liner, and save thousands of dollars over local installers! Installing your own inground pool liner is easy, when you take it step by step.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |